How to operate the plastic shredder blade correctly

At present, plastic crusher blades are widely used in various processing plants. In the past year, the promulgation of the new environmental protection law has become a hot topic. Nowadays, people use waste materials as a necessary machine to turn waste into treasure. How to correctly use plastic crushers, we should pay attention to the following points:

1. When the crusher stops, check whether the fastening bolts are firm and the wear degree of the easily worn parts. For the tooth crusher, we should also take advantage of the parking opportunity to remove the wood caught between the teeth.

2. Check whether the particle size of crushed products meets the requirements. If there are too many particles exceeding the specified size, find out the causes (such as too large gap between screen strips, too wide discharge opening, hammer wear, etc.) and take appropriate measures to eliminate them.

3. During the operation of the plastic crusher, it is necessary to pay attention to the temperature of the bearing, make sure that the bearing maintains a good lubrication state, and pay attention to whether the sound and vibration are abnormal. In case of abnormal conditions, stop the machine to check whether it is stuck by objects that are not easy to be broken or whether the machine parts are damaged.

4. Before starting the plastic crusher, we should manually move the driving wheel for oneortwo circles and confirm that the movement is flexible before starting it. Feed only after the crusher operates normally.

5. The safety device of the crusher shall be kept in good condition, and the safety device shall not be invalidated for convenience.

6. Before stopping the operation, stop feeding and discharge the materials in the machine, and then cut off the power supply of the motor.

7. The feeding of crusher shall be kept uniform to prevent overload. Prevent metal, wood and other objects that cannot be broken from falling into the machine. When it cannot be broken, the feed moisture shall not be too high; During wet crushing, it is necessary to maintain appropriate water volume to prevent blockage due to insufficient flushing and reduce production capacity.

8. Worn parts shall be replaced or repaired in time. So as not to reduce the effect greatly.